Navigation
SEARCH
TOOLBOX
LANGUAGES
modified on 7 October 2014 at 12:54 ••• 49,586 views

Bambino-210 Manual/Appendix B

From Manuals

Revision as of 12:54, 7 October 2014 by Support (Talk | contribs)
Jump to: navigation, search

Appendix B - Using an External JTAG with the BAM210

  • 1. Locate the LPC11U35 Virtual COM Port Binary
  • 2. Boot the MBED HDK into CRP DISABLED mode by shorting JP3 while connecting the USB Cable to USB1. A Image:CRP_DISABLED.png drive should appear.
  • 3. Program the Interface firmware by deleting the firmware.bin file and copy lpc11u35_vcom.bin to the CRP DISABLED disk.
  • 4. Reboot the Interface by disconnecting and reconnecting the USB1 cable without JP3 shorted
  • 5. Finished!

The JTAG connector now free to use with an external JTAG. A virtual COM port is now available on USB1. The signals used for the virtual COM port are listed below:

Signals Used and Connector Locations for Example 05-04
Signal LPC4330 PIN NAME BAM210E BAM210 BAM200E BAM200 Used for
USBTX P2_10 MBED-HDK MBED-HDK S10-4 n/p MBED-HDK Serial RX
USBRX P2_11 MBED-HDK MBED-HDK s10-5 n/p MBED-HDK Serial TX

PREVIOUS: Appendix A

Retrieved from "https://wiki3.micromint.com/index.php/Bambino-210_Manual/Appendix_B"