Electrum FAQ
From Manuals
(Difference between revisions)
(Created page with '__TOC__ =Frequently Asked Questions - Hardware= =Frequently Asked Questions - Software=') |
(→Frequently Asked Questions - Hardware) |
||
| Line 1: | Line 1: | ||
__TOC__ | __TOC__ | ||
=Frequently Asked Questions - Hardware= | =Frequently Asked Questions - Hardware= | ||
| + | ==How can I change the MAC address of the board?== | ||
| + | The Micromint Electrum is assigned a MAC address during production from the Micromint block 00:21:a3:xx:yy:zz and is stored on the U-Boot configuration as the 'ethaddr' environment variable. To prevent accidental changes to the MAC address, the bootloader console does not allow changing the MAC address once it is set. If you need to substitute the assigned MAC address you can clear the bootloader environment by executing the commands below from the bootloader console. After rebooting, you will be able to change the 'ethaddr' variable. Note that you will need to apply any other changes you made to the bootloader configuration. | ||
| + | |||
| + | Electrum> mw.b 0x20100000 0 4 | ||
| + | Electrum> cp.b 0x20100000 0xD0002100 4 | ||
| + | Copy to DataFlash... done | ||
| + | Electrum> reset | ||
=Frequently Asked Questions - Software= | =Frequently Asked Questions - Software= | ||
Revision as of 14:50, 15 December 2010
Contents |
Frequently Asked Questions - Hardware
How can I change the MAC address of the board?
The Micromint Electrum is assigned a MAC address during production from the Micromint block 00:21:a3:xx:yy:zz and is stored on the U-Boot configuration as the 'ethaddr' environment variable. To prevent accidental changes to the MAC address, the bootloader console does not allow changing the MAC address once it is set. If you need to substitute the assigned MAC address you can clear the bootloader environment by executing the commands below from the bootloader console. After rebooting, you will be able to change the 'ethaddr' variable. Note that you will need to apply any other changes you made to the bootloader configuration.
Electrum> mw.b 0x20100000 0 4 Electrum> cp.b 0x20100000 0xD0002100 4 Copy to DataFlash... done Electrum> reset