Bambino-210 Manual/Appendix B
From Manuals
(Difference between revisions)
(Created page with '09 ==Appendix A - Updating CMSIS-DAP Firmware== * 1. Locate the updated CMSIS-DAP binary file * 2. Boot the MBED HDK into CRP DISABLED mode by sh…') |
|||
| Line 1: | Line 1: | ||
[[Category: Bambino-210_Manual|09]] | [[Category: Bambino-210_Manual|09]] | ||
| - | ==Appendix | + | ==Appendix B - Using an External JTAG with the BAM210== |
| - | * 1. Locate the | + | * 1. Locate the [[Bambino_Documentation#System Files - mbed|LPC11U35 Virtual COM Port Binary]] |
* 2. Boot the MBED HDK into CRP DISABLED mode by shorting JP3 while connecting the USB Cable. A [[Image:CRP_DISABLED.png]] drive should appear. [[Image:BAM210E_CRP_DISABLED.png|center]] | * 2. Boot the MBED HDK into CRP DISABLED mode by shorting JP3 while connecting the USB Cable. A [[Image:CRP_DISABLED.png]] drive should appear. [[Image:BAM210E_CRP_DISABLED.png|center]] | ||
* 3. Program the Interface firmware by deleting the firmware.bin file and copying the new binary to the CRP DISABLED disk. | * 3. Program the Interface firmware by deleting the firmware.bin file and copying the new binary to the CRP DISABLED disk. | ||
Revision as of 12:32, 7 October 2014
Appendix B - Using an External JTAG with the BAM210
- 1. Locate the LPC11U35 Virtual COM Port Binary
- 2. Boot the MBED HDK into CRP DISABLED mode by shorting JP3 while connecting the USB Cable. A
drive should appear. 
- 3. Program the Interface firmware by deleting the firmware.bin file and copying the new binary to the CRP DISABLED disk.
- 4. Reboot the Interface by disconnecting and reconnecting the USB cable without JP3 shorted
- 5. Verify that the MBED disk comes up
- 6. Finished!
