04-02 SawtoothWave
From Manuals
(Difference between revisions)
| (One intermediate revision not shown) | |||
| Line 5: | Line 5: | ||
|+ align="bottom"|'''DAC0 Ouput Connector Location''' | |+ align="bottom"|'''DAC0 Ouput Connector Location''' | ||
|'''Signal''' | |'''Signal''' | ||
| - | |'''PIN NAME''' | + | |'''LPC4330 PIN NAME''' |
|'''BAM210E''' | |'''BAM210E''' | ||
|'''BAM210''' | |'''BAM210''' | ||
| Line 36: | Line 36: | ||
} | } | ||
| - | + | DAC0 was captured on the oscilloscope in the image below. | |
[[Image:BAM210_04_02.png|center|]] | [[Image:BAM210_04_02.png|center|]] | ||
Current revision as of 18:06, 17 September 2014
This example outputs a saw tooth wave form on the DAC output. The DAC output is on pin A5 of J8.
DAC0 for the MBED-SDK and the Bambino line of microcontrollers is mapped to the following locations:
| Signal | LPC4330 PIN NAME | BAM210E | BAM210 | BAM200E | BAM200 |
| DAC0 | P4_4 | J8-6 | J8-6 | S3-5 | S3-5 |
/*Program Example 4.2: Sawtooth waveform on DAC output. View on oscilloscope
*/
#include "mbed.h"
AnalogOut Aout(DAC0);
float i;
int main()
{
while(1) {
for (i=0; i<1; i=i+0.1) { // i is incremented in steps of 0.1
Aout=i;
wait(0.001); // wait 1 millisecond
}
}
}
DAC0 was captured on the oscilloscope in the image below.
