PicoJTAG Manual/Introduction
From Manuals
(Difference between revisions)
(Created page with '1 ==PicoJTAG Overview== PicoJTAG is a low-cost debugger for ARM Cortex M3 microcontrollers. It combines JTAG debugging with a RS-232 Virtual COM por…') |
(→PicoJTAG Overview) |
||
| (3 intermediate revisions not shown) | |||
| Line 1: | Line 1: | ||
[[Category: PicoJTAG_Manual|1]] | [[Category: PicoJTAG_Manual|1]] | ||
==PicoJTAG Overview== | ==PicoJTAG Overview== | ||
| - | + | Micromint USA's picoJTAG is a low-cost debugger for ARM microcontrollers. It combines JTAG debugging with a RS-232 Virtual COM port allowing software developers to connect a debugger and serial port to a computer with a single USB cable. The picoJTAG can also provide power to targets that are capable of accepting power on the 20-pin JTAG connector. Drivers are provided for IAR, Keil and GNU toolchains supporting ARM Cortex M targets. Third party FDTI debugger drivers can be used to support other targets. | |
==PicoJTAG Features== | ==PicoJTAG Features== | ||
Current revision as of 15:04, 26 September 2011
PicoJTAG Overview
Micromint USA's picoJTAG is a low-cost debugger for ARM microcontrollers. It combines JTAG debugging with a RS-232 Virtual COM port allowing software developers to connect a debugger and serial port to a computer with a single USB cable. The picoJTAG can also provide power to targets that are capable of accepting power on the 20-pin JTAG connector. Drivers are provided for IAR, Keil and GNU toolchains supporting ARM Cortex M targets. Third party FDTI debugger drivers can be used to support other targets.
PicoJTAG Features
- USB2.0 (high-speed, 480Mbits/sec)
- RS-232 Virtual COM Port
- Based on the FT2232H
- Plugs directly into Arm's standard 20-pin JTAG connector
- Capable of supplying power to targets JTAG connector